By Derek Roga, web developer in Vilnius, Lithuania, and founder of Test Print Page and Essence Technologies.
Craft printing is the most unforgiving printing a home machine does. A document forgives a millimetre of drift; a sheet of labels does not, because the error repeats on every label down the page until the last row prints across two stickers at once. The good news is that craft failures are almost never creative failures. They are alignment, scale and paper problems, and each one shows itself on a test sheet before it ruins a sheet of expensive blanks.
Print the alignment sheet before any label session and study the fine lines with the same suspicion you would give a crooked hem. If the lines step or double, every label on the page inherits that step, growing worse toward the bottom as the feed error accumulates. Run the printer's alignment routine, then verify with the sheet again rather than trusting the routine's cheerful completion message. Two minutes of verification is cheaper than one sheet of waterproof labels.
Templates for labels, cards and sticker sheets are drawn at exact size, and any fit-to-page or shrink setting quietly rescales them, usually by just enough to miss every die-cut edge while looking fine on screen. Print craft templates at 100 percent, actual size, with scaling off, and prove it with the ruler printed on the sheets at Test Print Page: measure the printed ruler against a real one before the blanks go in. If the ruler is short, a scaling setting somewhere is still on, in the application, the driver, or both.
Crafters who sell their work learn that ink dries darker and duller than it looks wet, and that matte sticker paper drinks colour differently from glossy. The colour and CMYK sheets give you a reference printed on your machine, with your ink, on plain paper: compare your craft colours against them and you can predict, roughly, how far a bright screen colour will settle. For a new design, print one test label on plain paper, let it dry a full ten minutes, and judge it in daylight before committing the sheet.
Label and card stock is thick, and its adhesive warms as it travels. Feed craft stock one sheet at a time, use the rear or manual feed if the printer has one so the sheet bends less, and never re-run a label sheet that has already been through once: a loosened label inside the mechanism is a repair bill, not a savings. If the printer offers a thick-paper or labels media setting, use it; it slows the feed and raises the heat in ways that visibly improve both grip and finish.
Every check here runs on the free sheets at Test Print Page, in A4 and US Letter, brand-neutral, with no account and nothing to install. Two minutes with an alignment sheet and a ruler, and your labels land where the die cut them to land.